Assemble wheel kits for generator

GENERATOR ASSEMBLY AND MOUNTING

If your Generator is supplied with a wheel kit, Please follow the instructions below

1. Place the bottom of the generator cradle on a flat,even surface.Temporarily place unit on blocks to ease assembly.

2. slide the axle through the wheel(Fig 1)

3. Slide the axle through the mounting braces on the cradle frame as shown(Fig

And a flat washer over the axle, then secure the wheel with a retaining pin(Fig 3.Fig 4)

4. Install the other wheel in the same manner

5. Secure each vibration mount to the support leg with a lock nut,and a cap screw(Fig 5)

6. Secure the support leg to the cradle with cap screws and lock nuts (Fig 6)

7. Position the handles on the cradle ,cap screws and lock nuts (Fig 7. Fig 8.Fig 9)

8. Check that all fasteners are tight and tires are inflated between 15-40 PSI